PE hygiene

General

The PE profiles have been developed especially for the use in the hygiene industry and as a substitute for wood. With this type we con-
sider the continuously increasing demands for
household & personal care products. The laths are extremely resistant to
abrasion and do not splinter in the event of overload. The spiked lattices
produced with these profiles can be equipped always according to the kind of application and load with transilon belts as well as with toothed belts. A toothed belt makes it possible to install a geared drive in connection with toothed wheels. This prevents belt slipping. We recommend the use of a toothed belt from a working width of 2.5 m.

Advantages

Flexible, smooth laths: no breaking – no splintering – a correct end product is always reached
Suitable for the modification of production facilities according to hygiene standards
Retrofitting of nearly every machine is possible – alternative profile forms can be supplied
Simple exchange of screwed laths without special tool
White (PE nature) or black laths available
Tight pin seat according to special pins

Description

Due to the following features a very low-wear and flexible spiked lattice has been created with this system. This has been achieved by the following details:

Spiked Lattice with black PE laths
  • The PE lath with the desired cross section offers a smooth surface. The laths are produced of flexible material. Compared to wooden laths they do not break immediately in the event of overload. Thus a higher reliability is reached. Equipped with these laths your machine will meet the hygiene demands easily and at low cost. If necessary we may also deliver a suitable feed conveyor.
  • The laths are fixed either with rivets, special screws or at toothed belts by tooth and screw.
  • The pins in profile specific sizes are provided with pressing, which prevents the pins from being pulled out. The pins can be protected against corrosion.
  • The belts can be chosen with respect to material and construction:
    • Transilon belts; multilayer PVC belts with fabric insert, the screw or rivet heads are sunk in the lowest PVC layer. Width as desired.
    • Toothed belt; 50 mm wide polyester belt reinforced with special fibers. Depending on the chosen profile we use different tooth forms. The use of toothed belts is recommended from a working width of 2.5 meters. For the conversion of the drive shaft we can offer you also low-cost gear wheels or toothed belts from our own production. The conversion to gear drive (positive drive) is possible from a shaft diameter of 140 mm.
  • Being pushed into the laths the polyester fabric strips seal the gaps. Very high pull-out strength is reached by woven in synthetic threads.
  • The endless splicing in the machine is a lap joint of the belts over 3 or 4 laths and is friction-locked by the screw connection.
Scroll to Top